When dealing with its high-concentration wastewater, the bag filter needs to be filtered through its equipment.Bag filterThe high-concentration wastewater to be treated in the medium enters the main body of the equipment directly through the water inlet.

Bag filterThe impurities in the stainless steel screen will be deposited on the stainless steel screen, resulting in a pressure difference.

The pressure difference between the inlet and the outlet will be monitored to a certain extent through its pressure difference switch. When the pressure difference reaches its set value, the electric controller feeds the water control valve and the drive motor signal to cause the following actions: the motor drives the brush to rotate, cleans the filter element, and the control valve opens to discharge sewage. The entire cleaning process only lasts for tens of seconds. After the cleaning is completed, the control valve is closed, the motor stops rotating, and the system returns to its initial state and begins to enter. The next filtering process.

After the bag filter is installed, its technicians will effectively carry out debugging, the filter time and cleaning conversion time of the equipment setting, etc., the treated water enters the human body through the water inlet, and the bag filter starts to work normally. When the preset cleaning time is reached, the electric controller will send a signal to the hydraulic control valve and the drive motor to trigger the following actions: the motor drives the brush to rotate, cleans the filter element, and the control valve opens to discharge sewage. The entire cleaning process only lasts for tens of seconds. .

Most of the damage to the bag mouth of the filter bag is within 30-40 cm of the bag mouth, which is mainly caused by blowing off and peeling off the bottom layer of the filter material. During the installation process, it is mainly caused by excessive compressed air, skewed nozzles, and deformation of the flower plate. Pay attention to the installation quality.